The String Attachment Kit was designed to enable you to customize your Stalker system to your individual desires, as well as your surroundings. After following the instructions below, you will be able to tie pieces of vegetation or other materials to your system to blend into your surroundings even more effectively...wherever that may be. Remember! This is your system...use your imagination and experience to guide you.

Contents:

Hook needle (1 each).
Nylon Cord (15 yards).
Instruction Sheet

Instructions:

Cut the provided nylon cord into sections. We recommend 12-inch sections; this should be sufficient length to tie on most vegetation. Take out and unroll your Stalker system and place it with the leaves facing up onto the floor or table.

The stitching attaching the leaves to the system are 3 inches apart, giving you a good reference measurement. We recommend the placement of strings to be approximately 12 inches apart, in staggered pattern. Starting at the top middle of the system (about three rows of leaves down), sew on the string by attaching it through the needle, and pushing the needle, and pushing the needle through the material. Tie the cord in a square knot to hold it in place.

Repeat step 4, working to each edge of the material, and then start over in the middle. Remember to stagger the placement of the cords to reduce the man made appearance of the vegetation once it is tied on. As you work your way down to the bottom of the system, stop sewing on ties approximately 10 inches from the bottom. This will prevent you from tripping over the ties if they are not in use.

Once you've completed tying on your cords, you're ready for the next time you need to use the system.

 

D-2 Stalker Hood Kit - $19.95

Hood Kits are available in all patterns for the D-2 Stalker Camouflage System. ( The D-2 Predator has an integral Hood built into it.) The hoods are fully adjustable and easily allow for people wearing glasses.